Woodworking rulers4/2/2023 This will be the perfect center of the board.Ī line may be drawn down the center of the board by completing these steps in multiple location along the length of the board and connecting the points with a line using the edge of the device. On a 12-inch device the 10 will be across from the 2.Īdjust the angle of the device across the board until the number 10 on the top right of the device is aligned with the right side of the board.Ĭheck to make sure both the 2 and the 10 on the top side of the device are aligned with the edges of the board, then mark the board at the 6” mark. In this example we aligned the 2” to the left edge. Identify the number on the top right of the device that is directly across from the number aligned to the left edge. To find the center of any board narrower than the device, use either side of the device and identify the center of the device.Īlign the device at an angle to the board so that the number on the top left is aligned with the edge of the board (in this case 2”). Continuing with the 12“long example, 2” will always be across from 10”. Similarly, there will always be corresponding number across from one another. The 6” mark on the top, will be directly across from the 6” mark on the bottom. Arrives by Thu, Dec 8 Buy Woodworking Crossed Rulers Hole Rulers Aluminum Alloy T-type Scriber Woodworking Measuring Tools Measuring Tools T-type Ruler. In the case of a 12” long measuring device, this would be at 6”. Because the device has graduations that start from either end, the center of the device can be found by locating where the same number is directly across from itself. Woodworking Ruler Precision Pocket Rule - 12, 8, 6 Inch Metal Slide Stop Marking Ruler Metric Inch Measuring Wood Working Scribing Rulers Measure Tools.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |